Pipeline Drying

The graphical user interface of Elmer
Post Reply
Andrew Lindsay
Posts: 1
Joined: 06 Jun 2011, 07:46
Antispam: Yes

Pipeline Drying

Post by Andrew Lindsay » 15 Jun 2016, 08:00

Dear Group,

I am trying to understand how difficult it would be to set up a model to calculate how long it would take to dry the inside of a pipeline by pumping dry air in one end and measuring the dew point at the other end.

Is this something that Elmer is able to do, and is there any tutorials on how to set up the various stages.

Ideally, I'd like a tutorial on how to design a pipeline section and then be able to pump gas through it, seeing the dynamic changes with time, then look at adding effects like evapouration etc.

Any assistance would be greatly appreciated.

Regards

Andrew

Post Reply