I am trying to understand how difficult it would be to set up a model to calculate how long it would take to dry the inside of a pipeline by pumping dry air in one end and measuring the dew point at the other end.
Is this something that Elmer is able to do, and is there any tutorials on how to set up the various stages.
Ideally, I'd like a tutorial on how to design a pipeline section and then be able to pump gas through it, seeing the dynamic changes with time, then look at adding effects like evapouration etc.
Any assistance would be greatly appreciated.
The graphical user interface of Elmer
1 post • Page 1 of 1