splitting a surface

[shevablue]

Hi everyone,
is it possible to divide a surface as shown in this picture:


[img]http://img339.imageshack.us/img339/2005/1341555354044.jpg[/img]

i have to split the surface (the red one) in three parts.

thanks a lot

[mzenker]

Hi,

I don't know if this is possible in ElmerGUI - I think you should do it within you CAD program before meshing.

Matthias

[shevablue]

it works.

thanks a lot

[saxonfahrer]

Hi shevablue,
what is the solution ? Can Elmer do this (and if yes: could you briefly describe the methode?)

Thanks.
saxonfahrer

[shevablue]

I've done with my cad software: NX 8.0