## magnetic field of a straight wire due to static current

Numerical methods and mathematical models of Elmer
Phlix
Posts: 11
Joined: 31 Aug 2018, 13:51
Antispam: Yes

### magnetic field of a straight wire due to static current

Dear Elmer-community,

I am facing a problem which is very close related to the test case which can be found here:

In fact, it is the same test except for the fact, that I use a different meshed geometry.
I want to compare the magnetic field with the results of the quasi-static case (E.g. Angular frequency =100rad/s) of the Elmer-GUI Tutorial 7 "Magnetic field induced by harmonic current in a wire".

If I use the provided test case with the wire.grd geometry and a desired current of 188.4 A to get the expected magnetic field of 0.037 T everything works fine.

But If I use my meshed geometry I get an implausible B-Field distribution as depicted in Figure.
B-FieldStaticWire.PNG (48.62 KiB) Viewed 909 times
In the .sif I only changed the boundary conditions.

I have applied the boundary conditions by using Gmsh and using the command:
ElmerGrid 2 4 GmshWire

I do not see any difference compared to the test case "mgdyn_steady_wire".

The sif File as well as the geometry are enclosed in this Post as zipFile.
StaticWire.zip
I highly appreciate if someone could help me.

Best regards,
Phlix

raback
Posts: 3697
Joined: 22 Aug 2009, 11:57
Antispam: Yes
Location: Espoo, Finland
Contact:

### Re: magnetic field of a straight wire due to static current

Hi Phlix

Nasty little problem in the sif file: You had wrong size of Target Boundaries in the AirSurface. Try with this:

Code: Select all

``````Boundary Condition 5
Name = "AirSurface"
Target Boundaries(4) = 1 2 9 12

AV {e} 1 = Real 0.0
AV {e} 2 = Real 0.0
End
``````
-Peter

Phlix
Posts: 11
Joined: 31 Aug 2018, 13:51
Antispam: Yes

### Re: magnetic field of a straight wire due to static current

Hi Peter,

thank you very much for checking my sif!

Best regards!

Phlix

Ps.
To everyone who is new to Elmer and want to check this case...
Unzip the attached file of the initial post, correct the mentioned mistake of the previous post in the sif file.
With the command prompt in windows go to the unzipped folder.

To execute the solver with the command prompt type:

ElmerSolver case.sif >elmersolver.log