Page 1 of 1

RE: MicroMeshGas Detector (Electrostatics)

Posted: 04 Jan 2018, 17:38
by kvaniekerk
Dear Elmer,

I have included the required files for the modelling exercise. (Please find
the 7z file) Please excuse the previous email. I have included

The top electrode is to be at -2000V. The bottom copper plate is to be set
at 0V. The wiremesh level should be set at -400V. The plastic pillar onto
which the wiremesh is laid should not be conductive.

I cannot seem to work out how to set the periodic boundary conditions for
the side surfaces of the model. Can you please explain?

Your assistance would be greatly appreciated.

Kind regards,
Karl van Niekerk

ME Engineering​ iThemba Labs
Mob: +27 79 323 7672