I'm a newbie in using Elmer and I've been tinkering around here and there.So here's my problem.So I created a model in FreeCAD and I used gmsh(saved the model as .unv file after meshing) to mesh it.I was able to import into ElmerGUI without any problem.I tried out a simple stress simulation and after I'm done entering the inputs,I tried to run the simulation but I got an error that says:
Code: Select all
Program received signal SIGSEGV: Segmentation fault - invalid memory reference.
Backtrace for this error:
#0 ffffffffffffffff.
Thanks in advance!