Hello
I have defined each 2d mesh triangle as different surface and then extruded it .
However at each edge between mesh elements ELMERGUI shows an edge as Boundary Index (which is not the case in general 3d meshes).
Now i am getting segmentation fault while running it , so is it because of this mesh?
Thank you for the time
Br
Ravi
Gmsh to Elmer 3D mesh boundary index at mesh edges
Gmsh to Elmer 3D mesh boundary index at mesh edges
- Attachments
-
- Capture.JPG
- (68.4 KiB) Not downloaded yet
-
- test.geo
- (79.13 KiB) Downloaded 276 times
-
- test.zip
- (83.2 KiB) Downloaded 293 times