how to simulate coil in magneto dynamic

[teofilBitron]

hello everyone,
I'm trying to evaluate the eddy current in the stator of a micro generator. Please have a look to the attached picture.
The question is: how is possible to simulate the coil? At the moment the ring of the coil is only representative footprint. Actually the coil is a 470 copper wire rings of total electrical resistance of 7 Ohm. Moreover the winding is closed with a load of 20 Ohm. So, at present, I impose the coil volume of a material with electrical conductivity in order to have, for the representative footprint, a total resistance of 27 Ohm. Is it right?

Many thanks in advance, Teofil