Discussion about coding and new developments

amrueda
 Posts: 5
 Joined: 19 Apr 2016, 02:43
 Antispam: Yes
 Location: Colombia
Post
by amrueda » 23 Jun 2016, 22:42
Dear Elmer team,
I am writing a solver for a system of 12 coupled PDEs. Since some of my equations are advectiondominated, I am implementing an FCTstabilization algorihm, which needs the solutions at time steps
n and
n1 in order to calculate the flux corrections and solve the system at time step
n+1.
I checked some source files and found out that the solution at time step
n is stored in
Is there a way to get the solution at time step
n1?
Thank you very much.
Kind regards,
Andrés

mzenker
 Posts: 1946
 Joined: 07 Dec 2009, 11:49
 Location: Germany
Post
by mzenker » 24 Jun 2016, 12:29
Hi,
I don't know for sure, but I think you would need to store it by yourself. You can examine the adaptive timestepping code for a possible way to do that.
HTH,
Matthias

raback
 Site Admin
 Posts: 3453
 Joined: 22 Aug 2009, 11:57
 Antispam: Yes
 Location: Espoo, Finland

Contact:
Post
by raback » 05 Jul 2016, 15:33
Hi Andrés
The number of previous timesteps that are stored depends on the time stepping method. If you use bdf then there is the keyword "bdf order" that defines the order, and this is also the number of previous timesteps required: N:th order scheme requires N previous timesteps.
Currently this may be married with the timestepping strategy. So if you do you require 2 previous steps, but use a 1st order scheme then you may need to do it yourself. The order of the solver is found in "Solver % Order".
It would probably be a rather small modification to the library to allow number of steps to be stored be larger than order of timestepping scheme but to my knowledge it has not been done.
Peter

amrueda
 Posts: 5
 Joined: 19 Apr 2016, 02:43
 Antispam: Yes
 Location: Colombia
Post
by amrueda » 05 Jul 2016, 23:20
Hello,
Thank you both. I am using BDF of order 1. Therefore, I have tried the following, but it still doesn't work:
 Add the integer variable StoreSteps to the type Solver_t in the file Types.F90 (line 721).
 Add the keyword to SOLVER.KEYWORDS
Code: Select all
Simulation:Integer: 'BDF Store Steps'
 Read the value from the SIF file in MainUtils.F90 (add line 849850):
Code: Select all
Solver % StoreSteps = ListGetInteger( SolverParams, &
'BDF Store Steps', Found)
 Allocate Solver % Variable % PrevValues correctly by modifying MainUtils.F90 (lines 14311433)
Code: Select all
ALLOCATE(Solver % Variable % PrevValues( &
SIZE(Solver % Variable % Values), MAX(Solver % TimeOrder, &
Solver % StoreSteps)))
 Store results of time step n1 by modifying SolverUtils.F90 (line 7180)
Code: Select all
Order = MAX(MIN(Solver % DoneTime, Solver % Order),Solver % StoreSteps)
What else should I do?
Thank you for your attention.
Kind regards,
Andrés