salomeToElmer - export Salome mesh to Elmer

Discussion about coding and new developments
panosvar
Posts: 34
Joined: 29 Oct 2019, 16:02
Antispam: Yes

Re: salomeToElmer - export Salome mesh to Elmer

Post by panosvar » 02 Dec 2019, 21:17

Yes, I get that too. Does it mean that if I call each boundary/body with these names in the sif file it will normally work?

kevinarden
Posts: 315
Joined: 25 Jan 2019, 01:28
Antispam: Yes

Re: salomeToElmer - export Salome mesh to Elmer

Post by kevinarden » 03 Dec 2019, 02:47

That i have never tried or tested.

panosvar
Posts: 34
Joined: 29 Oct 2019, 16:02
Antispam: Yes

Re: salomeToElmer - export Salome mesh to Elmer

Post by panosvar » 03 Dec 2019, 14:04

Do you know what happens if we don't assign a BC in a boundary? I've read somewhere that it behaves as hard wall (with Wave Flux 1 = 0), is that true?

kevinarden
Posts: 315
Joined: 25 Jan 2019, 01:28
Antispam: Yes

Re: salomeToElmer - export Salome mesh to Elmer

Post by kevinarden » 03 Dec 2019, 22:36

I believe it varies for every solver or ElmerModel in the model manual. I think in general if nothing is assigned to a boundary, then nothing happens or is transferred through (either into or out of the mesh) at that boundary. This will have different effect in every solver. For example in a heat transfer analyses no heat transfer across the boundary is equivalent to symmetric boundary condition. In solid mechanics no definition at a boundary means it is free to move/defect.

raback
Site Admin
Posts: 3498
Joined: 22 Aug 2009, 11:57
Antispam: Yes
Location: Espoo, Finland
Contact:

Re: salomeToElmer - export Salome mesh to Elmer

Post by raback » 04 Dec 2019, 11:44

Hi,

In FEM the "do nothing" BC or the "natural" BC depends indeed on the equation. When a weak form of the PDE is written a boundary integral term appears (Neumann BC). If this is not modeled it is zero. The boundary integral is typically some kind of flux (heat flux, electric current, normal force, etc.).

-Peter

Post Reply