Search found 5 matches
- 10 May 2022, 09:20
- Forum: General
- Topic: Heat Transfer with Air Gap
- Replies: 6
- Views: 987
Re: Heat Transfer with Air Gap
case.sif Thank you everyone for your suggestions. I have been somewhat successful in the analysis. Now I would like to write out the temperatures to a file. I made an attempt with the Savescalers procedure but no results were saved. I would also like to output the results for a particular body. Can...
- 01 May 2022, 04:41
- Forum: General
- Topic: Heat Transfer with Air Gap
- Replies: 6
- Views: 987
Heat Transfer with Air Gap
I am trying to model a section of a covered conveyor which carries material at high temperature. I want to perform a thermal transient analysis to determine when the material cools to a specified temperature. My concern is the air space above the hot material. It will increase in temperature so a co...
- 11 Apr 2022, 21:46
- Forum: General
- Topic: Heat radiation
- Replies: 23
- Views: 11413
Re: Heat radiation
Thank you.
I will reinstall Elmer and see what happens. You are right about the path. It does not include Elmer since that is the default.
Is there a possible problem by putting Elmer in the path?
I have used Elmer for several years without it being in the path.
Thank you.
George
I will reinstall Elmer and see what happens. You are right about the path. It does not include Elmer since that is the default.
Is there a possible problem by putting Elmer in the path?
I have used Elmer for several years without it being in the path.
Thank you.
George
- 11 Apr 2022, 10:22
- Forum: General
- Topic: Heat radiation
- Replies: 23
- Views: 11413
Re: Heat radiation and ViewFactors
I am trying to solve a heat transfer problem involving radiation. I decided to explore some of the sample and test problems first to see if everything was working as it should. There were a lot of problems with getting the geometry file into the correct format. Things that used to work did not. Once...
- 05 Apr 2022, 10:53
- Forum: ElmerGUI
- Topic: Impossible to select bodies
- Replies: 31
- Views: 5453
Re: Impossible to select bodies
Sometimes I like to bring into ELMER a model by reading a file of nodes and elements. The *.msh format works for this. Now there are no boundaries listed so I need to specify them. Does anyone have a suggestion for doing that? Most of my problems are heat transfer. In commercial programs (ANSYS) I c...