Search found 4 matches
- 23 Aug 2016, 15:35
- Forum: General
- Topic: Mesh not showing up
- Replies: 6
- Views: 6354
Re: Mesh not showing up
I went ahead and generated a mesh using the FEM workbench in FreeCAD. I then exported the mesh as an STL file. When I load that STL file into Elmer, I end up with the same situation of the mesh not showing up. The mesh summary does not have a lot of information in it, so I am wondering if a mesh is ...
- 23 Aug 2016, 14:26
- Forum: Installation & compilation
- Topic: Installation Error Microsoft Visual C++ 2010 Redistributable
- Replies: 3
- Views: 6745
Re: Installation Error Microsoft Visual C++ 2010 Redistributable
I had this issue on install, and figured it was not a problem. However, when I went to mesh a model, VC++2010 crashed and Elmer shut down.
- 23 Aug 2016, 14:09
- Forum: General
- Topic: Mesh not showing up
- Replies: 6
- Views: 6354
Re: Mesh not showing up
Thanks Matthias - I made some changes to my CAD model and re-exported it as a STEP file. Elmer loaded it and tried to mesh it, but Visual C++ Runtime crashed. When I was installing Elmer, it told me that it could not install VC++RT because I already had a newer version installed. Now I will look aro...
- 21 Aug 2016, 22:37
- Forum: General
- Topic: Mesh not showing up
- Replies: 6
- Views: 6354
Mesh not showing up
I used FreeCAD to generate a STEP file, which I imported into the Elmer GUI. The model shows up, but the mesh does not. I have tried using the View menus to show everything, but still cannot get the mesh. Note: My STEP file was generated in FreeCAD with the different components making up the part. I...